Moulding ID please
-
- Posts: 18
- Joined: Tue 01 Dec, 2015 7:20 pm
- Location: Lamorna Cornwall UK
- Organisation: Lamorna picture framing
- Interests: pasties
cream teas
ciders
Moulding ID please
I've been asked to match this moulding, does anyone know what it is?
The width is approximately 55mm.
Many thanks.
Re: Moulding ID please
Could be a plain moulding that has been painted white. have a look at the back
and see if there are any tell-tale dribbles. Is it all in one lump or two stacked sections?
In any case, if you peruse the Rose&Hollis catalogue you will no doubt find two profiles
that can be used to make it. Then all you need is some white paint and a brush.
and see if there are any tell-tale dribbles. Is it all in one lump or two stacked sections?
In any case, if you peruse the Rose&Hollis catalogue you will no doubt find two profiles
that can be used to make it. Then all you need is some white paint and a brush.
Watch Out. There's A Humphrey About
-
- Posts: 18
- Joined: Tue 01 Dec, 2015 7:20 pm
- Location: Lamorna Cornwall UK
- Organisation: Lamorna picture framing
- Interests: pasties
cream teas
ciders
Re: Moulding ID please
Its a one piece obeche moulding which was supplied finnished like that.
I don't particularly like it and suggested alternatives but it is to complete a set.
I don't particularly like it and suggested alternatives but it is to complete a set.
Re: Moulding ID please
There's this one from Mainline. ref 502 0011
It's 88mm wide though.
It's 88mm wide though.
Watch Out. There's A Humphrey About
-
- Posts: 18
- Joined: Tue 01 Dec, 2015 7:20 pm
- Location: Lamorna Cornwall UK
- Organisation: Lamorna picture framing
- Interests: pasties
cream teas
ciders
Re: Moulding ID please
Thanks Prospero, very similar profile and finish. Might have to ask the bandsaw about trimming to size if I can't get anything closer.
- JohnMcafee
- Posts: 1145
- Joined: Sun 10 Oct, 2010 9:58 am
- Location: Belfast
- Organisation: Scenes
- Interests: Picture Framing
Putting the world to rights - Location: Belfast
- Contact:
Re: Moulding ID please
Looks a bit like D&J Simons Boxx-0004 plus slip
- Attachments
-
- boxx.jpg (44.76 KiB) Viewed 4049 times
"A little learning is a dangerous thing"
(Also known as John, the current forum administrator)
(Also known as John, the current forum administrator)