The Framers Forum

Very nice job

As we are retiring we are now selling off our equipment and we are selling our Inmes IM30 single phase mitre saw. This has been a superb machine cutting excellent joints and as we used to make lots of ash frames it was brilliant (along with the Hoffman Router) in getting tight corner joints. It is i...

We are retiring and gradually selling off our equipment and stock and today we are selling the Hoffman Router X line 20 manual. It comes complete with a number of different sizes of dovetail (as pictured). The machine is in excellent condition. Price £500. It must be collected as these machines do n...

We sink mount ours too. Much easier and full visibility. We have done a few of these and they look stunning,especially if you have a picture of the recipient to give it context.

New price now £8500 including VAT

Seeing the moulding properly I can see why there are issues with this joining. It would clearly be difficult with the profile to join further in toward the rebate with any meaningful depth of wedge and of course going further to the chunky bit of the moulding would open out the rear of the joint. Th...

Adding a little more substance to Johns post, we have spoken to JWP Industries and it is their intention to build on the brand. Currently they have a person available to answer queries (like Bob did) and they are able to lift and shift the machines should people want it moved professionally.Also the...

Price reduction as we are now packing up.

£8500 which includes VAT

Now sold

Books now sold.

Hi rafe

PM'd you

Steve

Hi we have three framing books for sale which are in excellent condition, all by Vivian Kistler.

All at £10 each.

P&P would be £3.00 each

Hi Steven

Yes it is still for sale

Regards


Steve

It all goes in the woodburner in winter. I stockpile until then and all offcuts that are usable get left till I have nearly run out of stuff to burn then that gets chopped up.

You cant believe the rate at which moulding piles up

Slight change to the spec. After counting, there are approximately 300 mountboards. All Arqadia, Neilsen, Centrado

Steve N wrote: a lot of the suppliers now seem to use Tuffnells, so all my supplies get damaged ,

Well we used Arqadia who use DX logistics. We used to call them "Damage Xpected"

Multi master now sold..

Yes Mark, there are many uses including bending them through 90 degrees for fixing, but equally there are other methods of fixing, which I would say are safer, than using bent points. We probably used them for the more obvious fixings, but as you can see in the approximately 7 years we have had it w...

We are selling some spare Push Mate tools and points. Two push mates and 4 packs of points.

£10.00 the lot plus P&P at cost

We are selling our MultiMaster point gun as we have hardly ever used it. It is like new and comes with a box containing over 2000 points.

We are asking £50.00 plus P&P at cost