The Framers Forum

Hi all thanks for your replies. The pressure of reaching the gun is 4 bar and so certainly not too much pressure.
Thanks

Hello, I have an Omer pneumatic flexipoint gun as shown that works well but I want to reduce the depth that it fires the 15mm tabs into the frame rebate. At the moment it fires them in so that about 4mm is sticking out proud and these are hard to bend back and also don't really cover the MDF back by...

All sorted now. Chatted with Steve from Gunnar and he ran me through how to take the cutting head head off. It seemed that it was temporarily seized, probably by a small bit of card. I lubricated with a small amount of silicone spray ( non oily) and the machine is running perfectly again ! Great mac...

Hi David,
Yes all those are fine. It does straight cuts but not plunging on 45 degree. Thanks

Hello, I have an Gunnar F1 hybrid that has served me well for a year or two. Earlier on today while cutting several mounts from one sheet the blade stopped plunging. The foot however does come down onto the board and everything else seems to work as it should. I took the red cover off the cutting &q...

Hi Leigh,
I've sent a few PMs but one or two of them seem to be stuck in my outbox. Can you let me know if you have received them please ?
If you want you can text me on 07894260123.
Thanks
James

Any thoughts about my message regarding Minigraf 3?
Thanks

Any thoughts about my message regarding Minigraf 3?
Thanks

Hello any thoughts about the underpinner ?
Thank you

Thanks for your response. Is the machine in good working order and condition? Also where are you based and what is the best price pleas?. I ideally wanted a Minigraf 4 but this model will do
You are welcome to text me if you like on 07894260123
Thanks James

Hi Is this Minigraf 3 underpinner still available.? Thanks

As heading I am looking for a Minigraf 3 or 4 in perfect working order please and for reasonable price.
Thanks
Please text 07894260123 if you have one .

Hello,
Is there an underpinner among the items?
Thanks

Hi,
I am looking for a reasonably priced, perfectly working Minigraf 4 underpinner.
Anyone got one for sale please let me know.
Thanks 07894260123 ( please text)

Hello,
I am looking for a Minigraf 4 underpinner that is in perfect working order and for a reasonable price.
As near to Gillingham Dorset would be ideal.
Thanks
James

BTW I am using a thin line of viscous suoerglue down the middle of the mitres for extra strength.

I posted a message for advice yesterday because while making batches of frames from Polycore I was having problems getting the joints to be tight. When the clamps on the pneumatic Minigraf 4 underpinner held the moulding and the wedge was fired in it pulled the corners apart only slightly but enough...

Hi how much is this please, is it perfect working order and where are you please ?
Thanks

Thanks Mark

Hello, I am making batches of polycore frames but when using my pneumatic underpinner the joints are not tight. The mitres are being cut on a Morso with very sharp blades and the surfaces are flat and clean. When these are put together on a flat surface by hand they form a perfect joint with no gap....