Search found 105 matches
- Tue 21 Aug, 2012 11:46 am
- Forum: Help!
- Topic: Securing coins/ ribboned medallions
- Replies: 4
- Views: 2074
Re: Securing coins/ ribboned medallions
Hi, I always cut slits in the board for the ribbons to go through and just a small piece of fuse wire through the board around where the ribbon goes through the medallion will hold it pretty tightly. If you cut a circle in the board, so it is a tight fit for the coin, it will hold itself in place. T...
- Tue 21 Aug, 2012 7:38 am
- Forum: Business Matters
- Topic: Pricing Software
- Replies: 2
- Views: 2999
Re: Pricing Software
What a super star you are! I'll give that a try thanks
- Mon 20 Aug, 2012 1:12 pm
- Forum: Business Matters
- Topic: Pricing Software
- Replies: 2
- Views: 2999
Pricing Software
Hi I'm considering getting pricing software and have downloaded Bbest free trial. It seems ok as I only need it for prices not invoicing etc. This may be a stupid question, but do you have to input all your mouldings, or does any software come with say all Arqadia's moulding pre-loaded? Also when it...
- Mon 20 Aug, 2012 9:58 am
- Forum: Introductions
- Topic: Hi from Preston
- Replies: 8
- Views: 4609
Hi from Preston
Hi all. I have been framing in Preston for over 20 years, doesn't time fly when you're having fun?
Still learning all the time and getting unusual requests, so I haven't seen it all yet.
Look forward to seeing what other framers are up to on here.
Heather
Still learning all the time and getting unusual requests, so I haven't seen it all yet.
Look forward to seeing what other framers are up to on here.
Heather
- Tue 17 Jul, 2012 8:42 am
- Forum: Help!
- Topic: Gap in joints
- Replies: 14
- Views: 10531
Re: Gap in joints
I had this problem recently, after investing in new blades. It turned out that Morso did actually have a batch of faulty blades, so they were replaced by Mainline, who I had bought them off.
I do think that blades are often the problem, I have about 6 sets now and only 3 make perfect joints.
I do think that blades are often the problem, I have about 6 sets now and only 3 make perfect joints.