Gunnar Mat Creator Software on Mac?

Computerised Mount Cutters, Computers, other gadgetry.
Post Reply
Whitewater Gallery
Posts: 358
Joined: Sun 29 Jun, 2014 3:32 pm
Location: Polzeath
Organisation: Whtewater Gallery
Interests: Surfing, sailing

Gunnar Mat Creator Software on Mac?

Post by Whitewater Gallery » Tue 21 Oct, 2014 8:42 pm

A difficult decision made - my Gunnar F1 Hybrid will hopefully be installed on the 20th November - a deal sealed with an offer of a free surf lesson for Sarah?

I have not had to run any windows software since converting to Mac's 4 years ago, so have not had a need to try running Windows on a Mac. I know that you can get a program to enable Windows programs to run on a Mac but I wondered if anyone is doing this with CMC software?

For simplicity I guess ordering a PC is the way to go, but if the Mac option is working elsewhere it would be great to save some money!!

IFGL
Posts: 3049
Joined: Sun 06 May, 2012 5:27 pm
Location: Sheffield UK
Organisation: Inframe Gallery Ltd
Interests: Films ,music and art, my wife and kids are pretty cool too.
Location: Sheffield
Contact:

Re: Gunnar Mat Creator Software on Mac?

Post by IFGL » Tue 21 Oct, 2014 8:51 pm

you will be able to run the gunnar software through a windows emulator but it is highly doubtful it will be able to communicate with the hardware, you could install windows on a partition on your hard drive or install a separate hard drive with windows on, this should work.

Post Reply