Cove Mounts
Posted: Sun 15 Nov, 2009 5:07 pm
It's not that difficult to cut a cove mount by hand, but it would be a piece of cake with a CMC - anyone got a file for one, or is there an existing one in FMD that can be adapted?
It would need a scored square with triangles cut from each corner of it to the outside of the board and then the outside of the board cut. You couldn't cut the board to size first.
Sounds like something I could do myself now I think about it - just by selecting and messing about with the triangle shapes, but any tips/suggestions welcome anyway.
It would need a scored square with triangles cut from each corner of it to the outside of the board and then the outside of the board cut. You couldn't cut the board to size first.
Sounds like something I could do myself now I think about it - just by selecting and messing about with the triangle shapes, but any tips/suggestions welcome anyway.