Page 1 of 1
Designs Wanted
Posted: Sat 26 Sep, 2009 11:06 pm
by Keith
Hi.
A long shot but a customer wants to add a thistle and a rose to a mount, without stems.
Thanks Keith
Re: Designs Wanted
Posted: Mon 28 Sep, 2009 9:49 am
by Dermot
Not a long shot…..
The Rose is already in the Valiani CMC software, not sure about the Thistle, however if you get in touch with John a Merlin Mounts our resident Valiani mount expert here on the forum I have no doubt he will get you sorted.
http://www.merlinmounts.co.uk/
Re: Designs Wanted
Posted: Mon 28 Sep, 2009 1:00 pm
by Merlin
Hi Keith
The rose is in the library
This is a JPEG of a thistle. Any good.
thisltethumb.jpg
If you need it converting to .FU2 then just let me know
Re: Designs Wanted
Posted: Mon 28 Sep, 2009 1:10 pm
by Keith
Hi.....
and thanks for the replies.
I think that thistle would be just right John, if you could convert it and send to me It would be much appreciated.
Thanks Keith
Re: Designs Wanted
Posted: Mon 28 Sep, 2009 1:16 pm
by Merlin
Here is the .FU2 of the thistle above.
It will require a new blade and very careful prizing out of the fallout.
thistle.Fu2
Re: Designs Wanted
Posted: Fri 16 Jul, 2010 7:05 pm
by Bladerunner
Here is a picture of a design I did that incorporated a rose. It is on a Trucut machine so I don't know if it helps.
Swatch Picb.jpg
Thanks
Re: Designs Wanted
Posted: Mon 16 May, 2016 7:33 am
by frameartnyc
How it can be a rose?
My eyes are unable to look this green picture as a rose.
Tried a lot to see as an artists who have designed, but unfortunately i have defeated to think.