Moulding ID please

Ask for and give assistance
Post Reply
dreckly
Posts: 18
Joined: Tue 01 Dec, 2015 8:20 pm
Location: Lamorna Cornwall UK
Organisation: Lamorna picture framing
Interests: pasties
cream teas
ciders

Moulding ID please

Post by dreckly » Mon 22 Aug, 2016 11:41 am

IMG_2624.JPG
IMG_2624.JPG (1.49 MiB) Viewed 1572 times
Hello
I've been asked to match this moulding, does anyone know what it is?
The width is approximately 55mm.
Many thanks.

User avatar
prospero
Posts: 10449
Joined: Tue 05 Jun, 2007 5:16 pm
Location: Lincolnshire

Re: Moulding ID please

Post by prospero » Mon 22 Aug, 2016 11:48 am

Could be a plain moulding that has been painted white. have a look at the back
and see if there are any tell-tale dribbles. Is it all in one lump or two stacked sections?

In any case, if you peruse the Rose&Hollis catalogue you will no doubt find two profiles
that can be used to make it. Then all you need is some white paint and a brush. :D
Watch Out. There's A Humphrey About

dreckly
Posts: 18
Joined: Tue 01 Dec, 2015 8:20 pm
Location: Lamorna Cornwall UK
Organisation: Lamorna picture framing
Interests: pasties
cream teas
ciders

Re: Moulding ID please

Post by dreckly » Mon 22 Aug, 2016 11:56 am

Its a one piece obeche moulding which was supplied finnished like that.
I don't particularly like it and suggested alternatives but it is to complete a set.

User avatar
prospero
Posts: 10449
Joined: Tue 05 Jun, 2007 5:16 pm
Location: Lincolnshire

Re: Moulding ID please

Post by prospero » Mon 22 Aug, 2016 12:31 pm

There's this one from Mainline. ref 502 0011

Image

It's 88mm wide though. :?
Watch Out. There's A Humphrey About

dreckly
Posts: 18
Joined: Tue 01 Dec, 2015 8:20 pm
Location: Lamorna Cornwall UK
Organisation: Lamorna picture framing
Interests: pasties
cream teas
ciders

Re: Moulding ID please

Post by dreckly » Mon 22 Aug, 2016 1:07 pm

Thanks Prospero, very similar profile and finish. Might have to ask the bandsaw about trimming to size if I can't get anything closer.

User avatar
JohnMcafee
Posts: 1074
Joined: Sun 10 Oct, 2010 10:58 am
Location: Belfast
Organisation: Scenes
Interests: Picture Framing
Putting the world to rights
Location: Belfast
Contact:

Re: Moulding ID please

Post by JohnMcafee » Mon 22 Aug, 2016 3:10 pm

Looks a bit like D&J Simons Boxx-0004 plus slip
Attachments
boxx.jpg
boxx.jpg (44.76 KiB) Viewed 1523 times
"A little learning is a dangerous thing"

(Also known as John, the current forum administrator)

Post Reply