Moulding ID please

Get help and framing advice from the framing community
Post Reply
dreckly
Posts: 18
Joined: Tue 01 Dec, 2015 7:20 pm
Location: Lamorna Cornwall UK
Organisation: Lamorna picture framing
Interests: pasties
cream teas
ciders

Moulding ID please

Post by dreckly »

IMG_2624.JPG
IMG_2624.JPG (1.49 MiB) Viewed 3988 times
Hello
I've been asked to match this moulding, does anyone know what it is?
The width is approximately 55mm.
Many thanks.
User avatar
prospero
Posts: 11492
Joined: Tue 05 Jun, 2007 4:16 pm
Location: Lincolnshire

Re: Moulding ID please

Post by prospero »

Could be a plain moulding that has been painted white. have a look at the back
and see if there are any tell-tale dribbles. Is it all in one lump or two stacked sections?

In any case, if you peruse the Rose&Hollis catalogue you will no doubt find two profiles
that can be used to make it. Then all you need is some white paint and a brush. :D
Watch Out. There's A Humphrey About
dreckly
Posts: 18
Joined: Tue 01 Dec, 2015 7:20 pm
Location: Lamorna Cornwall UK
Organisation: Lamorna picture framing
Interests: pasties
cream teas
ciders

Re: Moulding ID please

Post by dreckly »

Its a one piece obeche moulding which was supplied finnished like that.
I don't particularly like it and suggested alternatives but it is to complete a set.
User avatar
prospero
Posts: 11492
Joined: Tue 05 Jun, 2007 4:16 pm
Location: Lincolnshire

Re: Moulding ID please

Post by prospero »

There's this one from Mainline. ref 502 0011

Image

It's 88mm wide though. :?
Watch Out. There's A Humphrey About
dreckly
Posts: 18
Joined: Tue 01 Dec, 2015 7:20 pm
Location: Lamorna Cornwall UK
Organisation: Lamorna picture framing
Interests: pasties
cream teas
ciders

Re: Moulding ID please

Post by dreckly »

Thanks Prospero, very similar profile and finish. Might have to ask the bandsaw about trimming to size if I can't get anything closer.
User avatar
JohnMcafee
Posts: 1145
Joined: Sun 10 Oct, 2010 9:58 am
Location: Belfast
Organisation: Scenes
Interests: Picture Framing
Putting the world to rights
Location: Belfast
Contact:

Re: Moulding ID please

Post by JohnMcafee »

Looks a bit like D&J Simons Boxx-0004 plus slip
Attachments
boxx.jpg
boxx.jpg (44.76 KiB) Viewed 3939 times
"A little learning is a dangerous thing"

(Also known as John, the current forum administrator)
Post Reply