The Framers Forum

Hello
I've been asked to match this moulding, does anyone know what it is?
The width is approximately 55mm.
Many thanks.

Could be a plain moulding that has been painted white. have a look at the back
and see if there are any tell-tale dribbles. Is it all in one lump or two stacked sections?

In any case, if you peruse the Rose&Hollis catalogue you will no doubt find two profiles
that can be used to make it. Then all you need is some white paint and a brush.

Its a one piece obeche moulding which was supplied finnished like that.
I don't particularly like it and suggested alternatives but it is to complete a set.

There's this one from Mainline. ref 502 0011



It's 88mm wide though.

Thanks Prospero, very similar profile and finish. Might have to ask the bandsaw about trimming to size if I can't get anything closer.

Looks a bit like D&J Simons Boxx-0004 plus slip