air operated under pinner

saltyowen123 · Post by **saltyowen123** » Wed 26 Apr, 2017 10:13 pm

My pneumatic underpinner seems to be working fine It is new to me so I am not sure how it works it clamps ok but no wedge nails shoot up I have looked underneath and the piston is working Where am I going wrong Can you help please

GeoSpectrum · Post by **GeoSpectrum** » Thu 27 Apr, 2017 1:42 am

What make is it?

saltyowen123 · Post by **saltyowen123** » Thu 27 Apr, 2017 7:18 am

It says ORTEGUIL on the casing Made in spain I bought it second hand Thanks

Chris_h · Post by **Chris_h** » Thu 27 Apr, 2017 8:28 am

Are your wedges placed the correct way round, this could stop them firing.

saltyowen123 · Post by **saltyowen123** » Thu 27 Apr, 2017 2:13 pm

They are placed point first with the tape at the top is this correct That is with the pionted end towards the piston Thanks

saltyowen123 · Post by **saltyowen123** » Thu 27 Apr, 2017 8:36 pm

The problem sorted thanks Itwas a small piece of nail wedged in the end stopping the machine from working All is now well .What air pressure should I be using i.e.the PSI can you advise Thanks

The Framers Forum

air operated under pinner

air operated under pinner

Re: air operated under pinner

Re: air operated under pinner

Re: air operated under pinner

Re: air operated under pinner

Re: air operated under pinner