Page 1 of 1
Replacing broken glass
Posted: Fri 08 Mar, 2019 11:51 am
by Rainbow
I've been asked if I could replace some broken glass in an aluminium frame, approx 30 x 40cm. Having taken it apart, I can see that the lip on which the glass would rest is only about 2mm. The previous glass was sealed in place with strips of resin.
I usually leave a bit of "give" between the glass and the frame, but with this job, I think the glass would have to fit pretty tight up to the frame so that it didn't slip out. Am I being unnecessarily concerned about fitting the glass so tight?
Re: Replacing broken glass
Posted: Fri 08 Mar, 2019 12:18 pm
by JFeig
The job is abnormally labor intensive. A rabbit of 2mm just not enough. It is time to get a chisel and hammer to remove the resin and make a properly wide rabbit. then there is the possibility of having glass crack later due to not having 100% of the resin removed.
Or
You have to sell them a new frame as the labor to remove the resin will be more than a new frame.
Re: Replacing broken glass
Posted: Fri 08 Mar, 2019 12:26 pm
by Rainbow
Thanks JFeig, although I wonder if I've used the wrong description in calling it resin as it's come off very easily and it was soft and pliable. The glass was sort-of pushed into it. Sorry about that.
Re: Replacing broken glass
Posted: Fri 08 Mar, 2019 12:41 pm
by poliopete
That sounds like a tight fit (2mm)
If I remember correctly, you have your glass cut a local glass merchants. I may be a good idea to take the frame to them for measuring.
FWIW I have always replaced broken glass, mounts and repaired frames in fact most anything that comes along but as Jerome and others have said "make sure you charge appropriately"
Peter.
Re: Replacing broken glass
Posted: Fri 08 Mar, 2019 1:07 pm
by Rainbow
Thanks, Pete. I'm happy to cut glass up to 24 x 20" so this one wouldn't be a problem. I get larger pieces cut locally though.