Blades for Keencut
Posted: Fri 29 Nov, 2019 12:27 pm
Hello my lovely friends, I am back after too long, sorry - framing has been neglected as I try to finish the house for my new workshop.
I am noticing that when I am cutting with my Futura, the blade enters at a strange angle but when it is actually cutting through all the board it is fine but I am getting weird bits where the corners almost look like the mountboard is being compressed. I shall try and replicate it in a photo and stick it on but I think my problem is using the wrong blades.
I use a mix of Arqadia conservation and Wessex Low Cost and the problem only seems to be with the Arqadia. Which blades should I be using?
Thank you my friendly framers.
I am noticing that when I am cutting with my Futura, the blade enters at a strange angle but when it is actually cutting through all the board it is fine but I am getting weird bits where the corners almost look like the mountboard is being compressed. I shall try and replicate it in a photo and stick it on but I think my problem is using the wrong blades.
I use a mix of Arqadia conservation and Wessex Low Cost and the problem only seems to be with the Arqadia. Which blades should I be using?
Thank you my friendly framers.