Hi All
I have a poster 1525mm X835mm. Anyone got any ideas re mounting this and would you suggest acrylic for the glazing? I perhaps would be better to sub it out to someone who ca press it in a the largest hot press or through a roller set up as I have neither, well not that big anyway. I have a small roller set up (Jetmount 26) and a HGP-260 which is not large enough to bond the poster down. Any recommendation IM in the midlands ST5 6BX.
Struggling with a large poster.
-
Justintime
- Posts: 2208
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Re: Struggling with a large poster.
Hinge it around a jumbo mountboard? Hinges tight at the top and a little loose bottom and sides with spacers.
Three mm glass is fine if you don't mind the weight or acrylic at a higher cost. Priced one up like this recently, customer was happier with the extra weight, we estimated around 12 kg all in, rather than the additional cost for acrylic.
Three mm glass is fine if you don't mind the weight or acrylic at a higher cost. Priced one up like this recently, customer was happier with the extra weight, we estimated around 12 kg all in, rather than the additional cost for acrylic.
Justin George GCF(APF)
Insta: georgetheframer
Insta: georgetheframer