Page 1 of 1
Hi
Posted: Wed 10 May, 2017 3:41 pm
by Ruffdog64
Hi everyone, i`m a carpenter looking to potentially start a framing business using some of the skills i already have, Harvey
Re: Hi
Posted: Wed 10 May, 2017 3:51 pm
by poliopete
Hi Harvey
Welcome to the Forum.
Carpentry skills have got to be an asset where framing is concerned and perhaps you should be considering "hand finishing" plain wood mouldings, lots of info, about that here.
Good luck in what ever you choose to do.
Peter
Re: Hi
Posted: Thu 11 May, 2017 1:08 pm
by JohnMcafee
Welcome aboard, Harvey.
Re: Hi
Posted: Tue 16 May, 2017 3:38 pm
by Ruffdog64
poliopete wrote:Hi Harvey
Welcome to the Forum.
Carpentry skills have got to be an asset where framing is concerned and perhaps you should be considering "hand finishing" plain wood mouldings, lots of info, about that here.
Good luck in what ever you choose to do.
Peter
Can you point me in the direction of the hand finishing section please?
Re: Hi
Posted: Tue 16 May, 2017 3:53 pm
by David McCormack
There isn't a separate forum for hand finishing but maybe there should
Search the posts by
Prospero and
NYAF for info about hand finishing techniques.
Re: Hi
Posted: Tue 16 May, 2017 4:08 pm
by poliopete
Hi Harvey
The small box on the top right marked "Search" type in "Hand Finishing" and over 1000 items re that subject are available.
Invaluable advice by Prospero and NYAF (and others) given so generously will give you so much food for thought.
Also, there is the "book mark" facility - to enable referring back.
Regards
Peter
Re: Hi
Posted: Tue 16 May, 2017 4:36 pm
by Ruffdog64
Thanks