Page 1 of 1
Storing a Ultimat
Posted: Sun 28 Jul, 2019 9:33 am
by Guitar Beard
Hi
I was wondering if anybody has a solution.
I am forever moving the thing around trying to find somewhere out of the way to store it (space is very tight and i normally use it on the kitchen table). Does anybody have a bracket or a "thingy" to hang it on a wall when not in use.
Many thanks
Jay
Re: Storing a Ultimat
Posted: Mon 29 Jul, 2019 10:35 am
by cleaver
Hi Jay,
I have seen them hanging in a framer's.
Personally, I'd want to have something at the base of it (like a little shelf or bracket), to take most of the mountcutter's weight. Nightmare if the long arm went out of whack - or even bolts/fixings got stressed etc.
Or how about a long, thin shelf (like a mantelpiece), on which it could lean on its long front edge....and rig up a wall fixing preventing it from toppling/getting knocked off?
Paul
Re: Storing a Ultimat
Posted: Tue 30 Jul, 2019 12:02 pm
by Guitar Beard
HI Paul
Thanks for your thoughts, i have the opinion also that the weight should go through the bottom. At the moment I have found a spare space behind a door where it is resting on its short edge, but laying on a piece of dense foam so that the lifting arm ? is not being put under any stress.
Jay
Re: Storing a Ultimat
Posted: Tue 30 Jul, 2019 3:43 pm
by Steve N
Re: Storing a Ultimat
Posted: Wed 31 Jul, 2019 8:20 am
by baughen
I use a custom flight case to store my mountcutter when it is not on the bench. Keeps it protected. But you still need the space to store the case. The case I have has wheels on one end to make it more moveable.