Underpinner losing "pressure" before compressor replenishes
Posted: Sun 11 Oct, 2020 7:56 pm
Hi,
I have a Minigraf underpinner and a Hydrovane compressor. They both work well together but I have noticed that the underpinner pressure drops for about the last ten wedges before the compressed replenishes. This means that the last wedges don't fully drive in. The pressure is otherwise plenty to drive edges into the
moulding I am using.
Any advice welcome. Thanks
I have a Minigraf underpinner and a Hydrovane compressor. They both work well together but I have noticed that the underpinner pressure drops for about the last ten wedges before the compressed replenishes. This means that the last wedges don't fully drive in. The pressure is otherwise plenty to drive edges into the
moulding I am using.
Any advice welcome. Thanks