Hi All,
I bought these 2 pieces of equipment last May (both from the forum). It's taken me a lot longer than planned to get my business set up (nearly there now!) and in the meantime I've bought a whole workshop full of equipment in a closing down deal.
So, these are now surplus to requirements. The Morso has hardly been used in the past year, just turned on and warmed up each week and a few cuts made to keep the system in shape. The Keencut has not been used at all.
Morso EH fully automated cutter £3,200
I have the original handbook and partial history from the guy I bought it from (Art Vaults in Shrewsbury).
Just had full service oil change and filter, deep clean and ready to go.
2 x spare sets of genuine blades . Sharpened and ready from lion. 3 blades in total
1 x spare set of bottom blades sharpened and ready. 2 blades in total.
Has left hand extension table.
Single phase 240v.
Keencut 4000 Glass and Board cutter £200
Already dismantled but ready to go. With instructions.
I'm in Ashtead, Surrey. J9 M25. I'll post some pictures shortly...
Thanks
Dean
Morso EH and Keencut 4000 for sale
Forum rules
All sellers are required to have a forum profile that identifies them clearly. (Such as - name, surname, location, business name et cetera)
All sellers are required to have a forum profile that identifies them clearly. (Such as - name, surname, location, business name et cetera)
-
- Posts: 45
- Joined: Fri 08 Nov, 2013 2:09 pm
- Location: Ashtead, Surrey
- Organisation: CASSONS framing
- Interests: painting, family, football, squash