The Framers Forum

Hello,
I bought these 2 pieces of equipment May 2017 (both from the forum). The Morso has hardly been used in the past year, just turned on and warmed up each week and a few cuts made to keep the system in shape. The Keencut has not been used at all.

Morso EH fully automated cutter £3,000
Had full service oil change and filter, deep clean and ready to go.
2 x spare sets of genuine blades . Sharpened and ready from lion. 3 blades in total
1 x spare set of bottom blades sharpened and ready. 2 blades in total.
Has left hand extension table.
Single phase 240v. Sorry about the pics being on the sides

Keencut 4000 Glass and Board cutter £200
Already dismantled but ready to go. With instructions.

I'm in Ashtead, Surrey about 1 mile from J9 M25.
Thanks
Dean

Hi, just to confirm..are you saying the 4000 is as new? and if so, is it the 48ins version and how big is it now dismantled (considering transport options) ?

Sorry probably wasn't clear enough, the Keencut is not new! The dismantled parts are a maximum length of 2200mm by approx 250mm section. I managed to get it my estate car when I picked it up. It's fairly bulky/heavy but I can help with it this end - you'd need a helping hand at the other. Will post a picture later.
Thanks
Dean

Did you sell your EH ?

Apologies for the delay in reply - been upto my eyes in house renovation. The Morso is still for sale.
Thanks