A friend has taken over a storage unit from a retired framer and been left both of these pieces of equipment.
The Ademco press looks like it could do with a test/service as it's been left with its top cover off, suggesting it needs fixing. It looks like a dial is missing too. On the plus side it has a pump with it.
The Keencut looks like it may be missing some parts and needs a good clean.
If there's any interest in either of these pm me or I guess they'll head to landfill..
Any offers considered.
They are both in Cardigan, West Wales.
Justin
Ademco heat vacuum press and Keencut Rondo.
Forum rules
All sellers are required to have a forum profile that identifies them clearly. (Such as - name, surname, location, business name et cetera)
All sellers are required to have a forum profile that identifies them clearly. (Such as - name, surname, location, business name et cetera)
-
- Posts: 1881
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Ademco heat vacuum press and Keencut Rondo.
- Attachments
-
- IMG_20190301_150303.jpg (4.28 MiB) Viewed 1333 times
-
- IMG_20190301_150752.jpg (523.44 KiB) Viewed 1333 times
Justin George GCF(APF)
Insta: georgetheframer
Insta: georgetheframer
-
- Posts: 1881
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Re: Ademco heat vacuum press and Keencut Rondo.
I meant recycled not landfilled, of course.
Justin George GCF(APF)
Insta: georgetheframer
Insta: georgetheframer
Re: Ademco heat vacuum press and Keencut Rondo.
I had an Ademco press which I have just junked.
If yours will pull a vacuum to over 20psi and the elements all work then you might have good machine. They are a bit sensitive
though and if the lid has been taken off then there's a good chance the seal is compromised.
The missing dial is a timer which can easily be replaced.
If yours will pull a vacuum to over 20psi and the elements all work then you might have good machine. They are a bit sensitive
though and if the lid has been taken off then there's a good chance the seal is compromised.
The missing dial is a timer which can easily be replaced.
Watch Out. There's A Humphrey About