May sound a silly question but my Morso has started not completing the final cut and leaves a small bit at the bottom back of the moulding (see photo) and for the life of me I can't work out what to adjust to make it a clean cut all the way through, it's had a recently sharpened set of blades fitted but I don't think that's the problem and advice would be welcomed
thanks in advance
Morso miter cut not going all the way help
- Mark Thornton
- Posts: 242
- Joined: Thu 08 Feb, 2007 4:00 pm
- Location: Yorkshire
- Organisation: Underpinner Spares
- Interests: Red wine - lots and lots of it.
- Location: Snaith, East Riding of Yorkshire
- Contact:
Re: Morso miter cut not going all the way help
The setting is mentioned in the later versions of the manual.
Mark
Mark
https://www.underpinner-spares.co.uk Framing equipment spare parts - Easy online ordering
- JKX
- Posts: 420
- Joined: Sun 08 Jan, 2023 10:25 pm
- Location: West Sussex
- Organisation: None - retired
- Interests: Gardening. Walking. DIY. Retired framer of 20 plus years, keeping my hand in.
Re: Morso miter cut not going all the way help
And here’s the manual!
https://www.thegrumble.com/data/manuals ... tsList.pdf
First check there’s nothing obstructing the foot pedal though - and the moving parts inside - sometimes shavings can get trapped and cause problems.
Blades wear down when they are sharpened. so it may be a case if adjusting downward travel with the threaded rod attached to the blade housing - should all be in the manual.
https://www.thegrumble.com/data/manuals ... tsList.pdf
First check there’s nothing obstructing the foot pedal though - and the moving parts inside - sometimes shavings can get trapped and cause problems.
Blades wear down when they are sharpened. so it may be a case if adjusting downward travel with the threaded rod attached to the blade housing - should all be in the manual.
John Turner
The ex framer Formerly Known As RoboFramer.
The ex framer Formerly Known As RoboFramer.
-
- Posts: 9
- Joined: Thu 12 Jun, 2014 11:31 am
- Location: oxfordshire
- Organisation: Cotswold Frames
- Interests: most things
Re: Morso miter cut not going all the way help
Many thanks for the reply's will see if i can sort as directed.