Retiring all frameing equipment must go

[howard robinson]

Hi everybody,
I am now retired and my frameing equipment needs to go to a new home.It was a part time business so it's not had a hard life.
Morso mitring machine model F (spare blades, need sharpening)
Cassese pneumatic underpinner CS199MXL(wedges of various sizes)
Cassese pneumatic flexy pin driver (half pack of flexipoints)
Large selection of mountboards and mouldings.
Any reasonable offer and buyer must collect
Please call Howard on 07973-177036

[Philip@Pinakothiki]

Hi there, give us an email so we can contact by email as well .

[Tudor Rose]

Hi Philip

The seller may be OK to post their email on the Forum. However, they may prefer not to do that at this point. If that is the case then you can contact the seller via private message, which is emailed to them, through the Forum. Underneath their details on the right hand side of their post, please click on the speech bubble next to Contact. That will allow you to send a private message.

This will sit in your Outbox on the system until they have read it.

Thank you.