Hi I have a Morso EH that serves me well. One think I notice is that when the cut is through the moulding it almost sounds like it is bottoming out. Is this normal ?
Should there be no noise when it has actually cut through the moulding and is just before returning up?
Thanks
Clunk noise from EH Morso like it is bottoming out.
-
boscawen46
- Posts: 169
- Joined: Sun 04 Sep, 2011 7:35 am
- Location: gillingham, dorset
- Organisation: james frederick
- Interests: framing,woodwork
-
Oldgrumpyface
- Posts: 30
- Joined: Fri 27 Sep, 2019 9:43 pm
- Location: East Neuk of Fife
- Organisation: Frameology St Monans
- Interests: Golf, Photography & cooking, then eating what I cook! (Ok I see the problem now!)
Re: Clunk noise from EH Morso like it is bottoming out.
Hi, not sure if same based on your description but I had an issue with a clunk at bottom of cut before returning and was a loose bolt on where the draw bar meets the bow bar
Ill Hope this attaches
Regards,
Allan
Ill Hope this attaches
Regards,
Allan
You do not have the required permissions to view the files attached to this post.
-
boscawen46
- Posts: 169
- Joined: Sun 04 Sep, 2011 7:35 am
- Location: gillingham, dorset
- Organisation: james frederick
- Interests: framing,woodwork
Re: Clunk noise from EH Morso like it is bottoming out.
Thanks Allan. I'll have a look in the morning. Cheers for making the effort to get back.