Hi all. May I pick your brains! I don’t use acrylic - only real glass, however a regular customer has asked for two frames with acrylic in. Sizes are 25.9x19.7 & 21.4x20.7cm
Q1: Would 2mm be ok or should I buy 3mm thickness ?
Q2: suggestions on how to cut down a large sheet please? Straight edge and sharp blade?
Thanks in advance!
Acrylic for frames
-
Parm
- Posts: 62
- Joined: Fri 19 Sep, 2014 7:25 pm
- Location: Essex
- Organisation: Studios
- Interests: Classic car restoration
-
Justintime
- Posts: 2533
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Re: Acrylic for frames
2mm is absolutely fine for those sizes! You can order cut to size from Wessex. I have used a wall mounted panel cutter with acrylic blade, but I'll guess repeated strokes with a Stanley knife would work too if you have strong arms. Just don't scratch it.
Justin George GCF(APF)
-
Parm
- Posts: 62
- Joined: Fri 19 Sep, 2014 7:25 pm
- Location: Essex
- Organisation: Studios
- Interests: Classic car restoration
Re: Acrylic for frames
Thank you!
-
pramsay13
- Posts: 1512
- Joined: Tue 27 Sep, 2011 11:46 am
- Location: Stonehouse, Lanarkshire
- Organisation: Picture Framer (ML)
- Interests: picture framing (no, really!) sport, music
- Contact:
Re: Acrylic for frames
2mm is fine at that size. You can order cut to size from most suppliers or cut your own.
A hooked blade is good for this and use repeated strokes and then snap over the edge of the table.
A hooked blade is good for this and use repeated strokes and then snap over the edge of the table.