Morso wanted!

bez7293 · Post by **bez7293** » Fri 11 Apr, 2008 10:09 am

Hello
I'm after a Morso mitre machine to start framing my own pictures. When working as a picture framer, I used this type of cutter and found it ideal for doing the job perfectly.

I've been looking on eBay, but they are usually nowhere near me.

Thankyou for looking!
[/list]

valpendleton · Post by **valpendleton** » Fri 11 Apr, 2008 2:16 pm

Hello Bez 7293
We have a spare morso that we would like to sell. It has hardly been used & all mechanical parts are in excellent working order. It was stored in a barn, so has some superficial rust, but nothing a rub over with fine wire wool wouldn't sort out. We want £575 for it. We're based in Brackley, Northants...not too far away. Tel Chris or Val on 01280 702462 if you are interested.

GL@profile · Post by **GL@profile** » Fri 11 Apr, 2008 4:35 pm

There are three for sale in Mega Equipment sale thread below.
Best wishes
Guy

valpendleton · Post by **valpendleton** » Tue 15 Apr, 2008 11:08 am

Hello again Bez7293

Perhaps I made the rust sound a lot worse than it is ! There's very little & only on a couple of areas. I can send you a photo if you like.

Val

kev@frames · Post by **kev@frames** » Tue 15 Apr, 2008 5:43 pm

dont let the rust worry you. mine (1974) had to be dismatled and left in a sawn down drum of red diesel for a week to get the rust off and free it up , and its still going strong (albiet painted with red hammerite) 14 years later....

which is more than can be said of the Mike's Land Rover -erm fishing boat. cough.

valpendleton · Post by **valpendleton** » Wed 16 Apr, 2008 11:09 am

hahaha! Would love to hear more about Mike's Land Rover ...

Morso now SOLD

Val

valpendleton · Post by **valpendleton** » Wed 23 Apr, 2008 3:20 pm

Unfortunately we were messed around with here & so the morso is still for sale.

Val

smorgo · Post by **smorgo** » Wed 07 May, 2008 8:12 pm

valpendleton wrote:Unfortunately we were messed around with here & so the morso is still for sale.

Val

Oh no, it isn't

It's currently sitting in my garaged being soaked in WD40 and carressed into its full magnificent splendour.

So, thanks very much Val (and Chris). It's got a nice shiny new set of blades that I picked up on the way home and it's going to be doing some serious chomping very soon.

Regards,
Steve

Moglet · Post by **Moglet** » Wed 07 May, 2008 8:50 pm

Congrats on the new toy, Steve, and congrats on the sale to Val! Win-win!

valpendleton · Post by **valpendleton** » Wed 07 May, 2008 9:48 pm

Cheers chaps!

Nice to do business with you Steve and once again... best of luck with the framing venture. It's a good business to be in, despite anything we may have said today to the contrary! We've stuck at it for 28 years, so it can't be that bad!

Val

The Framers Forum

Morso wanted!

Morso wanted!

Morso wanted

Re Morso required

morso wanted

Re: morso wanted

morso wanted