How to cut panels for mounting? (Old System 4000 question)

[iggam]

Hello,

I am considering the purchase of an old Keencut System 4000 in order to cut panels of forex, foamboard, gatorfoam, etc. I have read on the forum that some of you have used this machinery, so I'd like to ask:

1. Will it cut Forex (of 3mm and 5mm thickness)?

2. Will it cut foamboard (of 3mm and 5mm thickness)?

3. Will it cut Gatorfoam (10 - 13mm thickness) or similar panels?

4. Will it cut "hard" panels such as aluminium or aluminium composites (Dibond and so on)?

PS: in case you are curious, the owners asks 650 euro for the used machinery.

[Grahame Case]

hello,

it cuts forex and foamboard no problem not sure about gatorfoam