If you use a hand held roller to press down prints on to sticky board, you sometimes find that it can mark the paper. Usually this can be cleaned off with an eraser.
But to eliminate the problem, clean the roller by running it over the tacky surface of a scrap piece of the sticky board.
No more skid marks.
Also works on the little follower wheel of a Valliani mountcutter.
Skid Marks
- John
- Site Admin
- Posts: 1886
- Joined: Sun 27 Apr, 2003 8:00 pm
- Location: Ireland
- Organisation: Tech Support
- Interests: Forums and stuff
- Location: Belfast
- Contact:
Skid Marks
HOW Much!?
EstLite Picture Framing Software
EstLite Picture Framing Software
-
- Posts: 11008
- Joined: Sat 25 Mar, 2006 8:40 pm
- Location: Devon, U.K.
- Organisation: The Dartmoor Gallery
- Interests: Lost causes, saving and restoring old things, learning something every day
- Location: Glorious Devon
I've never encountered these skid marks, do you use the release paper between the roller and the print, or just roller over the print directly?
Where I first worked as a framer and was trained, the practice was to peel back the release paper and carefully stick-down the print. Then the release paper was replaced over the sticky board and the print, then it could be pressed down with a roller if you wish or more usually pressed down in a dry-mounting press at 60 degrees centigrade, which causes any trapped air to expand and be expelled. It works for me!
Cheers,
Mark
Where I first worked as a framer and was trained, the practice was to peel back the release paper and carefully stick-down the print. Then the release paper was replaced over the sticky board and the print, then it could be pressed down with a roller if you wish or more usually pressed down in a dry-mounting press at 60 degrees centigrade, which causes any trapped air to expand and be expelled. It works for me!
Cheers,
Mark