I wish I could get.......

Trinity · Post by **Trinity** » Mon 25 Jul, 2011 3:56 pm

a brass picture plate with one hole slotted to compensate for the 1/2 a drill width that I'm out of level. The slotted aperture would enable minor adjustments until the second (fixed position) screw is fitted. It's the dremil for now but does anyone know if you can get them please.

Roboframer · Post by **Roboframer** » Mon 25 Jul, 2011 4:05 pm

These any good? http://www.lionpic.co.uk/product/MULTIP ... ,1602.aspx

Jonny2morsos · Post by **Jonny2morsos** » Mon 25 Jul, 2011 7:00 pm

I reckon I could find a few uses for those at work and home and at 8 quid for a hundred thay have to be a bargain.

Trinity · Post by **Trinity** » Mon 25 Jul, 2011 8:17 pm

Just a bit heavy on the eye either side of a picture for me but definately a hundred and one uses for these.
More care less dremil!

Roboframer · Post by **Roboframer** » Mon 25 Jul, 2011 8:39 pm

OK - this then http://www.lionpic.co.uk/product/Heavy- ... ,1576.aspx Lion have many slotted fixings.

Trinity · Post by **Trinity** » Mon 25 Jul, 2011 9:10 pm

Not yet, the picture plates stick out either side of the frame, fixing it flat and tight to the wall.

The Framers Forum

I wish I could get.......

I wish I could get.......

Re: I wish I could get.......

Re: I wish I could get.......

Re: I wish I could get.......

Re: I wish I could get.......

Re: I wish I could get.......