Sticking velcro loop to board

Graysalchemy · Post by **Graysalchemy** » Fri 05 Dec, 2014 12:50 pm

Yes thats it I buy it from tool station or screwfix this stuff.

Glimpse · Post by **Glimpse** » Fri 05 Dec, 2014 2:26 pm

Thanks again, I'll give it a whirl...

Post by **Tudor Rose** » Sat 06 Dec, 2014 12:04 am

We've used the foam backed fabric and glue method on boards in the past and usually ended up with patches where it comes away over time. The last lot we did we used the self adhesive version of the fabric sold by Arqadia and apart from it being a bit hair raising sticking it down on a load of 8ft by 4ft boards it actually was less stress than glueing. We put the whole lot under weight over a weekend before putting them on the wall. So far we've had no problems, no patches failing and they still look good as new.

silvercleave · Post by **silvercleave** » Sat 06 Dec, 2014 8:07 am

Welcome back Spit, not seen you on here for a long time, hope all is well, anyway Welcome Back

oh by the way, same trouble with velcro, always nervous when one is removed and the customer has a cross stitch on the desk

regards

Ian

Roboframer · Post by **Roboframer** » Sat 06 Dec, 2014 9:11 am

The thread's over 7 years old Ian

silvercleave · Post by **silvercleave** » Sat 06 Dec, 2014 11:26 pm

The Framers Forum

Sticking velcro loop to board

Re: Sticking velcro loop to board

Re: Sticking velcro loop to board

Re: Sticking velcro loop to board

Re: Sticking velcro loop to board

Re: Sticking velcro loop to board

Re: Sticking velcro loop to board