Page 2 of 2
Re: Tatting
Posted: Mon 13 May, 2013 11:16 pm
by Roboframer
Ta!
It is 464502 - Larson Juhl 'Fenice' - it's not that expensive a moulding, about six quid per metre/£1.83 per ft. That range is selling well for us.
Re: Tatting
Posted: Mon 13 May, 2013 11:28 pm
by IFGL
Selling ok for us to, I thought it was a bit more than that, I maybe selling it a bit too expensive then , oh well
Re: Tatting
Posted: Wed 15 May, 2013 8:07 pm
by MITREMAN
Great job. Robo
Re: Tatting
Posted: Thu 30 May, 2013 10:36 pm
by pramsay13
Nice, what have you used for a spacer?
Re: Tatting
Posted: Thu 30 May, 2013 10:49 pm
by Roboframer
5mm black foam board, didn't have to be very deep - 4 or 5mm - which was just as well as it's not a deep rebated moulding. If we are using a deep rebated moulding and the spacer is deep enough to be easily seen then we usually use foam board plus mount board to match.