The Framers Forum

Hi all we'll just picked up my Morso F cutter second hand but hardly used. I have been playing with it today and noticed that the cuts were not quite clean as I had hoped however the previous owner had the machine for 14 years and hasn't had the blades sharpened as he hardly used it. Can the blades be swapped around so the bottom edges that never get used be put at the top of the opposite side. Hope I have explained this right.

depends which blades you have on
http://www.lionpic.co.uk/equipment-tool ... rso_Blades

If you have normal single-sided blades where each end is the same angle like this /______/ then no. If you have double sided blades that go like this \_____/ then yes.

But it's probably best to get them sharpened anyway.

.

Ok if I need to get them sharpened where and how lol sorry

From Maidstone, here http://www.wessexpictures.com/ashford.html