Page 1 of 1
joining small moulding
Posted: Thu 15 Dec, 2016 4:44 pm
by nickhood
Some time ago I had a small tool that sat in front of the Fence on my Minigraf 44. It was two small lengths of metal joined by a swivel which when placed up against the fence it formed a lower fence it was great for small mouldings that sit lower than the standard fence. I have made a couple of wooden ones but they never worked as well as the metal one. Does any one know where I can buy one
Re: joining small moulding
Posted: Thu 15 Dec, 2016 5:24 pm
by David McCormack
This the
Cassese equivalent, it may work on your machine?
Re: joining small moulding
Posted: Thu 15 Dec, 2016 7:15 pm
by nickhood
That's the one David, thanks for your help. Have a good Christmas
Re: joining small moulding
Posted: Thu 15 Dec, 2016 11:18 pm
by David McCormack
And you
Re: joining small moulding
Posted: Fri 16 Dec, 2016 9:19 am
by kartoffelngeist
I just thought that was part of the underpinner, been sat on my cassesse since I started here! Didn't even think about taking them off!
Re: joining small moulding
Posted: Fri 16 Dec, 2016 9:34 am
by David McCormack
kartoffelngeist wrote:Didn't even think about taking them off!
I bet if you take it off now and then need it later for a small moulding, you won't be able to find it again