Page 1 of 1
boxing title belt
Posted: Wed 24 May, 2017 1:09 pm
by The Common Framer
hiall
Need some advice. Please see attached photo. Customer wants to mount this belt BUT - it must be removable.
Thought about velcro but no good. Any ideas?
Much appreciated.
Matt
Re: boxing title belt
Posted: Wed 24 May, 2017 1:54 pm
by Jamesnkr
I was going to suggest using the press studs/buckles at each end. But it would sag. So requires some support from the middle. So you're going to have to do *something*. Said he helpfully...
So what about something that is more presentation case like, so that the belt is displayed on a tilted shelf? i.e. so that it's lying down, but it's angled so that it can hang on the wall.
Re: boxing title belt
Posted: Wed 24 May, 2017 2:21 pm
by The Common Framer
hi
\i like that idea.A small shelf would do it!
thanks
MAtt
Re: boxing title belt
Posted: Wed 24 May, 2017 9:21 pm
by pramsay13
I'm sure there was an article in Art and Framing Today magazine a few months back.
I'll see if I can find it.
Re: boxing title belt
Posted: Thu 25 May, 2017 12:17 pm
by Steve N
what does the back of the belt look like
Re: boxing title belt
Posted: Thu 25 May, 2017 3:29 pm
by The Common Framer
Hi all
All sorted - will [post pic when finally completed. I did put in a small "shelf".
cheers for your help
Re: boxing title belt
Posted: Fri 30 Jun, 2017 8:15 am
by The Common Framer
Hi
Sorry - promised to post a pic when done: see attached.
I built a small shelf out of gold moulding. By luck there was also a threaded hole in the top of the centre piece of the belt that allowed me to put a bolt through the boards at the back and secure.