Excalibur 5000 clamp
Posted: Tue 15 Aug, 2017 2:57 pm
Hello there, Looking for some advice for my new acquisition I've purchased a used Excalibur 5000 and one thing I have noticed now that it has been re assembled is the main clamp when pushed forward is not particulary close to the main flat sections of the machine, even fully forward there is a 3/16 to 1/4" gap, certainlly enough to slide in 2 or 3 layers of standard mountboard without it actually holding them in place.
What am I missing? should there be large flat feeder boards behind on both sides perhaps.
I have read the manual regarding various pressures that can be applied for different boards/glass but it seems to be still far away.
thanks all, regards Alan
What am I missing? should there be large flat feeder boards behind on both sides perhaps.
I have read the manual regarding various pressures that can be applied for different boards/glass but it seems to be still far away.
thanks all, regards Alan