FTAGH- Kity 618 Cast Aluminium Table Saw
Posted: Tue 10 Oct, 2017 10:38 am
With the topic about table saw, I realised that I have a kity table saw which needs some tlc, but works. I used to use it as it is, but replaced it with a cast iron machine.
The blade is a 250mm freud blade (I use these on alk my machines), and the only problem is with the raise/drop mechanism so the blade is always at full height.
I have seen that it needs a pin or something simple to get this working and then it will work a treat.
It is an induction motor so is quiet, and the fence does not move (a problem with cheaper machines)
If this would be of use to anyone, you can have it for free.
The blade is a 250mm freud blade (I use these on alk my machines), and the only problem is with the raise/drop mechanism so the blade is always at full height.
I have seen that it needs a pin or something simple to get this working and then it will work a treat.
It is an induction motor so is quiet, and the fence does not move (a problem with cheaper machines)
If this would be of use to anyone, you can have it for free.
- 20171010_112618.jpg (5.61 MiB) Viewed 4433 times
- 20171010_112611.jpg (5.04 MiB) Viewed 4433 times
