Page 1 of 1
Wanted: vertical cutting head for Keencut Laser 1200
Posted: Thu 18 Jan, 2018 12:30 pm
by Acro
Yes, I know its an ancient piece of kit, but somebody may have some spare bits in a drawer
The Laser I bought second hand only had the bevel cutter.
Re: Wanted: vertical cutting head for Keencut Laser 1200
Posted: Thu 18 Jan, 2018 1:29 pm
by Framemaker Richard
I'm sure you have done this... but have you checked if Keencut have any parts? I seem to remember they were quite good at sending parts when I had a Laser years ago, even though it was no longer made.
Re: Wanted: vertical cutting head for Keencut Laser 1200
Posted: Thu 18 Jan, 2018 2:44 pm
by Acro
Yes thanks, I did check with them. They were very helpful but told me the Laser model was discontinued over 25 years ago so they didn't have much more than spare blades.