Morso EH and Keencut 4000 for sale
Posted: Thu 24 May, 2018 5:03 pm
Hi All,
I bought these 2 pieces of equipment last May (both from the forum). It's taken me a lot longer than planned to get my business set up (nearly there now!) and in the meantime I've bought a whole workshop full of equipment in a closing down deal.
So, these are now surplus to requirements. The Morso has hardly been used in the past year, just turned on and warmed up each week and a few cuts made to keep the system in shape. The Keencut has not been used at all.
Morso EH fully automated cutter £3,200
I have the original handbook and partial history from the guy I bought it from (Art Vaults in Shrewsbury).
Just had full service oil change and filter, deep clean and ready to go.
2 x spare sets of genuine blades . Sharpened and ready from lion. 3 blades in total
1 x spare set of bottom blades sharpened and ready. 2 blades in total.
Has left hand extension table.
Single phase 240v.
Keencut 4000 Glass and Board cutter £200
Already dismantled but ready to go. With instructions.
I'm in Ashtead, Surrey. J9 M25. I'll post some pictures shortly...
Thanks
Dean
I bought these 2 pieces of equipment last May (both from the forum). It's taken me a lot longer than planned to get my business set up (nearly there now!) and in the meantime I've bought a whole workshop full of equipment in a closing down deal.
So, these are now surplus to requirements. The Morso has hardly been used in the past year, just turned on and warmed up each week and a few cuts made to keep the system in shape. The Keencut has not been used at all.
Morso EH fully automated cutter £3,200
I have the original handbook and partial history from the guy I bought it from (Art Vaults in Shrewsbury).
Just had full service oil change and filter, deep clean and ready to go.
2 x spare sets of genuine blades . Sharpened and ready from lion. 3 blades in total
1 x spare set of bottom blades sharpened and ready. 2 blades in total.
Has left hand extension table.
Single phase 240v.
Keencut 4000 Glass and Board cutter £200
Already dismantled but ready to go. With instructions.
I'm in Ashtead, Surrey. J9 M25. I'll post some pictures shortly...
Thanks
Dean