Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
We bought the second hand machine and after being a pig to square was working fine.
Now the mdf head has starting running out.... not too bad over a short length but over 3ft could run out 3 or 4mm +?
I wondering if there is some adjustment Im missing or a bearing knackered ?
There doesnt seem to be much movement in the cutting head but this all a bit new to me...
The glass cutting head is a little out but not within a tolerance that is acceptable.
Any help very appreciated before the machine gets a grinder to it
The cutter is old but little used.
Many thanks in advance Dave
Check that the two cutting wheels are free to rotate. One (or both) can jam up with dust build-up. They can be slackened
off. But not too much, they shouldn't be wobbly. Give the area a good clean while you are at it. Sometimes putting a thin shim
of card behind the block (at the top or bottom - depending on the direction of the run-off) can make the block run true again.
