Hello all
I am sure this is a really stupid question but here goes. If I set the fences like the manual says I get an inside gap on the last join.Therefore I need to move the left fence towards me to get 45 degree cuts. Does that mean I need to physically bend the moulding to make it slightly concave i.e corespond to the slighly concave fences?
Hope this makes sense.
Thanks
Morso fence question
- Mark Thornton
- Posts: 245
- Joined: Thu 08 Feb, 2007 4:00 pm
- Location: Yorkshire
- Organisation: Underpinner Spares
- Interests: Red wine - lots and lots of it.
- Location: Snaith, East Riding of Yorkshire
- Contact:
Re: Morso fence question
Yes
https://www.underpinner-spares.co.uk Framing equipment spare parts - Easy online ordering
-
- Posts: 13
- Joined: Wed 25 Jul, 2018 12:50 pm
- Location: northern ireland
- Organisation: solitaire fine arts
- Interests: art, cinema, gaming and getting run ragged by my kids
Re: Morso fence question
Short and sweet
Thanks
Thanks
- David McCormack
- Posts: 1442
- Joined: Tue 02 Aug, 2011 10:14 am
- Location: South Lakes
- Organisation: Framing
- Interests: Cycling, walking, darkroom photography and laughing a lot!
- Location: Cumbria
- Contact:
Re: Morso fence question
When your left fence is set correctly to give x4 snug corners, then it may not be dead flush with the right fence. When you make you final cut i.e. in the last notch, make sure you pull both sides of the moulding flush up against both fences. For wide mouldings you may not be able to pull the moulding flush against the fences during the first couple of chops but you will for the last couple.
Hope that makes sense, if not just follow advice in the previous post
Hope that makes sense, if not just follow advice in the previous post
"You know, there's a right and wrong way to do everything!"
Oliver Hardy.
https://www.instagram.com/davidaustinmccormack/
Oliver Hardy.
https://www.instagram.com/davidaustinmccormack/
- Mark Thornton
- Posts: 245
- Joined: Thu 08 Feb, 2007 4:00 pm
- Location: Yorkshire
- Organisation: Underpinner Spares
- Interests: Red wine - lots and lots of it.
- Location: Snaith, East Riding of Yorkshire
- Contact:
Re: Morso fence question
Lol, i thought i summed it up nicely, oh well it's back to charm school for me then
Mark
Mark
https://www.underpinner-spares.co.uk Framing equipment spare parts - Easy online ordering