Underpinner help (Alfamachines Minigraf 44)
Posted: Sat 27 Jul, 2019 7:23 pm
I have an issue with an Alfamachines Minigraf 44.
I purchased the unit second hand and when I had my morso installed that chap kindly installed the underpinner and gave it a service. He advised that it needed a new hammer, so sent that to me and I installed that ok. The vertical pressure regulator was loose so tried to tighten it and snapped it. So ordered a new one of Lion and installed it tonight.
While it does work a lot better, whatever I try (with pressure etc) I cannot get the v wedge to go in as far as id like for a clean finish. I have had the Minigraf machines in the past so know what they can do.
I don’t, however know how to adjust this to push the nail in further – please see attached image. Can anyone point me in the right direction please.
I purchased the unit second hand and when I had my morso installed that chap kindly installed the underpinner and gave it a service. He advised that it needed a new hammer, so sent that to me and I installed that ok. The vertical pressure regulator was loose so tried to tighten it and snapped it. So ordered a new one of Lion and installed it tonight.
While it does work a lot better, whatever I try (with pressure etc) I cannot get the v wedge to go in as far as id like for a clean finish. I have had the Minigraf machines in the past so know what they can do.
I don’t, however know how to adjust this to push the nail in further – please see attached image. Can anyone point me in the right direction please.