Page 1 of 1
Unknown object during a sort out!
Posted: Thu 10 Jun, 2021 11:52 am
by Frangipaniframer
Hi Forum!
We’re having a bit of a clear up and also trying to fix one of our machines. We’ve come across this object, the boss can’t remember what it’s for! Any ideas welcome
Re: Unknown object during a sort out!
Posted: Thu 10 Jun, 2021 12:25 pm
by Not your average framer
That is a toggle clamp and I think it is likely to belong to a Keencut wall mounted Glass and flat material cutter!
Re: Unknown object during a sort out!
Posted: Thu 10 Jun, 2021 12:30 pm
by Frangipaniframer
Not your average framer wrote: ↑Thu 10 Jun, 2021 12:25 pm
That is a toggle clamp and I think it is likely to belong to a Keencut wall mounted Glass and flat material cutter!
Thanks you!
we thought so but couldn’t figure out where it slides into.
Re: Unknown object during a sort out!
Posted: Thu 10 Jun, 2021 1:01 pm
by Not your average framer
It slides into the lower front edge of the horizonal rail on which you side glass or flat materials in to the machine. It looks like the one used on the System 4000. I don't know if it is also the same for the excaliber cutters.