Cassese CS199MXL Underpinner for sale
Posted: Tue 20 Jul, 2021 3:13 pm
We have for sale a Cassese CS199MXL underpinner for sale, previously used full-time in our mail-order framing workshop but relegated to a secondary/backup machine several years ago as we switched to the newer CS200 CART for most of our work. Over the past 3 years this machine has seem less and less work until it was put in storage during the pandemic - now we are clearing out and have decided to sell it!
Sold as seen, £750 ex VAT - collection only from our workshop in Chesterfield, Derbyshire.
There is a possibility of a working demo using our compressed air system upon collection depending on when the collection would take place (can't cause too much disruption to our daily operation).
The machine was in full working order last time it was used several months ago, but is likely in need of a service to work at its full quality level. The hammer block in particular will need replacing eventually (we replace ours about once every 18 months now) to run smoothly which will set you back about £160. Overall the machine has been extremely reliable and all of the general maintenance procedures are in the instructions, which we can supply with the machine.
Sold as seen, £750 ex VAT - collection only from our workshop in Chesterfield, Derbyshire.
There is a possibility of a working demo using our compressed air system upon collection depending on when the collection would take place (can't cause too much disruption to our daily operation).
The machine was in full working order last time it was used several months ago, but is likely in need of a service to work at its full quality level. The hammer block in particular will need replacing eventually (we replace ours about once every 18 months now) to run smoothly which will set you back about £160. Overall the machine has been extremely reliable and all of the general maintenance procedures are in the instructions, which we can supply with the machine.