Hi I have a Morso EH that serves me well. One think I notice is that when the cut is through the moulding it almost sounds like it is bottoming out. Is this normal ?
Should there be no noise when it has actually cut through the moulding and is just before returning up?
Thanks
Clunk noise from EH Morso like it is bottoming out.
-
boscawen46
- Posts: 148
- Joined: Sun 04 Sep, 2011 7:35 am
- Location: gillingham, dorset
- Organisation: james frederick
- Interests: framing,woodwork
-
Oldgrumpyface
- Posts: 29
- Joined: Fri 27 Sep, 2019 9:43 pm
- Location: East Neuk of Fife
- Organisation: Frameology St Monans
- Interests: Golf, Photography & cooking, then eating what I cook! (Ok I see the problem now!)
Re: Clunk noise from EH Morso like it is bottoming out.
Hi, not sure if same based on your description but I had an issue with a clunk at bottom of cut before returning and was a loose bolt on where the draw bar meets the bow bar
Ill
Hope this attaches
Regards,
Allan
Ill
- Look here
Regards,
Allan
-
boscawen46
- Posts: 148
- Joined: Sun 04 Sep, 2011 7:35 am
- Location: gillingham, dorset
- Organisation: james frederick
- Interests: framing,woodwork
Re: Clunk noise from EH Morso like it is bottoming out.
Thanks Allan. I'll have a look in the morning. Cheers for making the effort to get back.