soo… I changed blades today , other set off to get sharpened .
The set that are off were cutting ok but not a perfect smooth cut but were ‘seated’ fine ( they l didn’t stick when down )
Fitted newly sharpened set and they kept sticking down , the cut was pretty perfect though !
Anyways I faffed about loosening / moving / re tightening until it wasn’t sticking on down cut … but now the cuts aren’t great ( see photos )
To be honest it was a bit hit or miss cutting before I swapped over there would usually be as per the photos a small chunk pushed/ removed from vertical edge but I was just blaming the blades on needing sharpened.
If I move them forward and get a good cut then the blades stick down , but move them back a teeny tiny bit and I get the cuts shown in photos
So I’m thinking either BOTh sets of blades are done ? Or I’m missing something I should be tightening or loosening or checking?
Is it correct that the bottom blades/guide ( the part closest to the sharp blades when down ) is slightly misaligned ? See photos of the bit I mean , and blades and the cuts it’s currently doing
Thanks in advance for any tips or suggestions.