I've a client coming in to discuss a stained glass panel that he would like framed. As this is a new to me, I'm curious as to if there are any special considerations I need to allow for for such a project.
I've looked at a few videos online, and a couple seem to use channeled frames to hold the glass. I'm hoping this isn't the norm, as I'm not yet a dab hand at routing - unless you can readily buy pre-channeled mouldings.
Framing Stained Glass
-
RobM
- Posts: 236
- Joined: Mon 17 Jun, 2024 8:41 am
- Location: Newcastle
- Organisation: TBC
- Interests: music, film, reading...the usual stuff
-
Justintime
- Posts: 2500
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Re: Framing Stained Glass
I have done a couple of smallish 300x450 panels.
Things I would look out for:
- is the piece flat?
-is the lead work in good condition, retaining structural integrity?
- how off square is it?
I used a strong oak moulding, with oak spacers behind, flush with the back, allowing it to be hung/stood up in front of a window.
If the panel is sagging at all I'd consider putting it behind glass for additional strength/protection. It's one of those jobs that until it's in your hands you don't really know what you're getting into.
Things I would look out for:
- is the piece flat?
-is the lead work in good condition, retaining structural integrity?
- how off square is it?
I used a strong oak moulding, with oak spacers behind, flush with the back, allowing it to be hung/stood up in front of a window.
If the panel is sagging at all I'd consider putting it behind glass for additional strength/protection. It's one of those jobs that until it's in your hands you don't really know what you're getting into.
Justin George GCF(APF)
Insta: georgetheframer
Insta: georgetheframer