Loads of Kit!!

[Gesso&Bole]

Over the last couple of months, I have been assembling my workshop. In order to get all of the bits and pieces that I needed, I have purchased the entire contents of 3 framing workshops.

Unsurprisingly there has been some duplication, and I now have some surplus equipment. I am in no huge rush to dispose of this, as I have plenty of storage space, but if it is useful to someone, the cash boost to my business would be beneficial, since I am behind schedule in opening the shop.

This is what I have. It is all at my premises in Derby. If any of it is of interest PM me.

Morso, metric, with LH arm and 2 sets of blades, one sharp one not.

Cassese 88 Manual underpinner – does not look like this has had much use. Comes with various different shaped ‘heads’ and the full instruction book.

Keencut Ultimat 40 inch. This looks to be mint condition.

Keencut Rondo oval and circle cutter. Probably donkeys years old, but not had much use, and has the little plastic case of extras. I tested it and cut a half-decent oval first time!

Ademco 2226 Hard bed press complete with floor stand. Clean and tidy and in full working order. (Bloody heavy though).

Keencut Excalibur 5000. This needs some attention to the glass/blade cutting head. It has a brand new MDF cutting head.

Keencut System 4000. Older than the Excalibur, but in good working order, clean and tidy cuts glass and board perfectly

Bambi Compressor. This looks brand new. It is the budget range, single pot with wheels.

I also have quantities of moulding and standard mountboard that may be useful for anyone starting up - these at about one third trade price

[stubrowner]

I would be interested in a spare set of morso blades if your prepared to seperate, and high rebate supports if you have any?

[Gesso&Bole]

Sorry Stu, I think anyone buying a Morso would want 2 sets of blades. But I will bear you in mind if I find someone who doesnt! Did you see the thread recently about the rebate supports?

[upload]

Hi im intertesed in the Bambi Compressor.

What model is it ?

thanks

[wingerdave]

Hi I'm interested in either the Keencut System 4000 or the Keencut Excalibur 5000 how much were you thinking ?
Thanks
Dave Images framing

[Gesso&Bole]

PMs sent to Upload and Winger