Loads of Kit!!
Posted: Thu 20 May, 2010 7:03 pm
Over the last couple of months, I have been assembling my workshop. In order to get all of the bits and pieces that I needed, I have purchased the entire contents of 3 framing workshops.
Unsurprisingly there has been some duplication, and I now have some surplus equipment. I am in no huge rush to dispose of this, as I have plenty of storage space, but if it is useful to someone, the cash boost to my business would be beneficial, since I am behind schedule in opening the shop.
This is what I have. It is all at my premises in Derby. If any of it is of interest PM me.
Morso, metric, with LH arm and 2 sets of blades, one sharp one not.
Cassese 88 Manual underpinner – does not look like this has had much use. Comes with various different shaped ‘heads’ and the full instruction book.
Keencut Ultimat 40 inch. This looks to be mint condition.
Keencut Rondo oval and circle cutter. Probably donkeys years old, but not had much use, and has the little plastic case of extras. I tested it and cut a half-decent oval first time!
Ademco 2226 Hard bed press complete with floor stand. Clean and tidy and in full working order. (Bloody heavy though).
Keencut Excalibur 5000. This needs some attention to the glass/blade cutting head. It has a brand new MDF cutting head.
Keencut System 4000. Older than the Excalibur, but in good working order, clean and tidy cuts glass and board perfectly
Bambi Compressor. This looks brand new. It is the budget range, single pot with wheels.
I also have quantities of moulding and standard mountboard that may be useful for anyone starting up - these at about one third trade price
Unsurprisingly there has been some duplication, and I now have some surplus equipment. I am in no huge rush to dispose of this, as I have plenty of storage space, but if it is useful to someone, the cash boost to my business would be beneficial, since I am behind schedule in opening the shop.
This is what I have. It is all at my premises in Derby. If any of it is of interest PM me.
Morso, metric, with LH arm and 2 sets of blades, one sharp one not.
Cassese 88 Manual underpinner – does not look like this has had much use. Comes with various different shaped ‘heads’ and the full instruction book.
Keencut Ultimat 40 inch. This looks to be mint condition.
Keencut Rondo oval and circle cutter. Probably donkeys years old, but not had much use, and has the little plastic case of extras. I tested it and cut a half-decent oval first time!
Ademco 2226 Hard bed press complete with floor stand. Clean and tidy and in full working order. (Bloody heavy though).
Keencut Excalibur 5000. This needs some attention to the glass/blade cutting head. It has a brand new MDF cutting head.
Keencut System 4000. Older than the Excalibur, but in good working order, clean and tidy cuts glass and board perfectly
Bambi Compressor. This looks brand new. It is the budget range, single pot with wheels.
I also have quantities of moulding and standard mountboard that may be useful for anyone starting up - these at about one third trade price