mitre chop saw
-
- Posts: 16
- Joined: Wed 14 Apr, 2010 5:05 pm
- Location: Fort William
- Organisation: Penguin Corner
- Interests: Photography, Penguins, Cats
mitre chop saw
Can anyone reccomend a good electric mitre saw for cutting moulding that's too big for the Morso?
-
- Posts: 124
- Joined: Fri 27 Feb, 2009 4:56 pm
- Location: Cork Ireland
- Organisation: Cork
- Interests: Sailing, Cycling, Hill walking
Re: mitre chop saw
Ive used a De Walt DW703 with good results. Never as fine a finish as a morso but you can always use the morso to shave the last sliver off to give a good finish.
Re: mitre chop saw
Not if it's too wide for the morso, but you could use a disc sander.emeraldart wrote:you can always use the morso to shave the last sliver off to give a good finish.
- ceebdub
- Posts: 68
- Joined: Thu 25 Nov, 2010 3:08 pm
- Location: nr Bicester
- Organisation: Nr Bicester
- Interests: Joinery,silversmithing,photography,motorsport
- Contact:
Re: mitre chop saw
I use a Makita and Bosch in my joinery business
Re: mitre chop saw
To big for most workshops, expensive and need 3 phase electricity, but I would ditch the morso and buy a Cassese 939 or newer model twin bladed saw. You get a far better cut than any morso and can take hefty 5" mouldings.
Not practical for most people but they are the dogs danglies.
AG
Not practical for most people but they are the dogs danglies.
AG
-
- Posts: 673
- Joined: Mon 29 Nov, 2010 12:20 pm
- Location: Halifax, West Yorkshire
- Organisation: Abacus Picture Framing and Gallery
- Interests: Picture Framing, Furniture making.
Re: mitre chop saw
Hi there
We use an Omga "10 with built under extraction with good results.
You need a blade with lots of teeth as well.
We use an Omga "10 with built under extraction with good results.
You need a blade with lots of teeth as well.