MORSO EH and KEENCUt 4000 FOR SALE

[Dean Casson]

Hello,
I bought these 2 pieces of equipment May 2017 (both from the forum). The Morso has hardly been used in the past year, just turned on and warmed up each week and a few cuts made to keep the system in shape. The Keencut has not been used at all.

Morso EH fully automated cutter £3,000
Had full service oil change and filter, deep clean and ready to go.
2 x spare sets of genuine blades . Sharpened and ready from lion. 3 blades in total
1 x spare set of bottom blades sharpened and ready. 2 blades in total.
Has left hand extension table.
Single phase 240v.

IMG_0371.JPG (2.26 MiB) Viewed 4081 times

IMG_0370.JPG (2.02 MiB) Viewed 4081 times

IMG_0369.JPG (1.92 MiB) Viewed 4081 times

IMG_0373.JPG (2.8 MiB) Viewed 4081 times

IMG_0374.JPG (1.82 MiB) Viewed 4081 times

Sorry about the pics being on the sides

Keencut 4000 Glass and Board cutter £200
Already dismantled but ready to go. With instructions.

I'm in Ashtead, Surrey about 1 mile from J9 M25.
Thanks
Dean

[Buster]

Hi, just to confirm..are you saying the 4000 is as new? and if so, is it the 48ins version and how big is it now dismantled (considering transport options) ?

[Dean Casson]

Sorry probably wasn't clear enough, the Keencut is not new! The dismantled parts are a maximum length of 2200mm by approx 250mm section. I managed to get it my estate car when I picked it up. It's fairly bulky/heavy but I can help with it this end - you'd need a helping hand at the other. Will post a picture later.
Thanks
Dean

[theprint.ninja]

Did you sell your EH ?

[Dean Casson]

Apologies for the delay in reply - been upto my eyes in house renovation. The Morso is still for sale.
Thanks