Fully serviced Morso blades

[breery]

Just replaced my Moros blades with a set that came back from Lion that they said were fully serviced but they are not exactly the same width. One is about 1 to 2mm narrower. Will this effect the cut (I have only cut narrow mouldings so far). Has anybody had this problem before and if so did Lion do anything about it. I Emailed them two days ago but have heard nothinh back so far.

[prospero]

If they can still be lined up at the front edge then you should have no problem. If not I would think the wider one needs to be ground to match the other. Otherwise the cut might go wonky or worse the cutter block channel might wear faster.

[breery]

Thanks prospero, They line up fine at the front just that one side of the V is very slightly shorter.